Sequence Control with Raspberry Pi + Arduino UNO and OpenPLC

To prevent students from being densely packed when conducting experiments, set up the system so that the remote screen can be controlled by VNC, assuming that the experiments are conducted in different rooms on the same LAN. VNC (Virtual Network Computing) is the ability to call up the screen of another computer to your own computer and control it from your own computer. This is different from a VPN (Virtual Private Network).This will allow us to direct the experiment in progress and instructions to a remote room in the school.
The Raspberry Pi 4 and Arduino are excellent devices for learning IoT and can be used to teach remotely. By using OpenPLC for this, learning sequence control can be done without a PC. Let's learn the basics of controlling sequences with Raspberry Pi 4+Arduino+OpenPLC.
This book focuses on the usage of OpenPLC. It also explains how to make and control an elevator experimental device, which is an applied experimental device for sequencing, using cardboard in consideration of the SDGs. We hope you will use this book to learn the basics of sequence control.
Contents
1.Introduction ・・・・・5
2.Raspberry Pi ・・・・・7
2.1 Raspberry Pi4 Model B
2.2 Installing the OS for Raspberry Pi
(1) Downloading the OS
(2) Connection to USB, HDMI
(3) Setting up the OS
(4) USBメモリ
(5) Copying the screen
(6) When you want to connect to a wired LAN
2.3 Arduino　UNO
2.4 Installing the Arduino-IDE
2.5 Installing OpenPLC
(1) Install the OpenPLC editor
(2) Download Arduino FIRMWARE
(3) Installing Runtime
(4) Checking operation
3．Basic sequence circuits ・・・・・67
(1) make and break contacts
(2) Basic logic circuits
(3) Sequence basic circuit
Example (1)
Example (2)
4. Devices used in the experiment ・・・・・83
(1) LED
(2) Potentiometer
(3) CDS cell
(4) Motor driver
(5) Reed switch
(6) Photo coupler
5. Sequence Control with OpenPLC ・・・・・88
(1) Self-hold circuit (stop priority circuit)
(2) Circuits that repeat ON/OFF
(Chapter 4, Example 1)
(3) A circuit that turns on after a certain time
(Chapter 4, Example 2)
(4) Periodic operation circuit
(5) Circuit that lights up
when the button is pressed 10 times
(6) Circuit of analog input
(7) Circuit of analog output
(8) Analog input/output circuits
(9) Motor control
6. Construction and experiments of the
elevator test equipment. ・・・・・129
6.1 Construction of the elevator equipment
and experiments
(1) Experimental circuit
(2) Experimental apparatus
①elevator car section
②Body section
6.2　Elevator control experiment
＜Example of experiment－1＞
＜Example of experiment－2＞
＜Example of experiment－3＞
＜Example of experiment－4＞
7　VNC ・・・・・147
7.1　Setting up VNC on Raspberry Pi
7.2　Setting up VNC on the computer
7.3　Remote connection
Appendix (Elevator experimental apparatus design drawing) ・・・・・160
References ・・・・・162


Sequence Control with Raspberry Pi + Arduino UNO and OpenPLC Fast Download
Sequence Control with Raspberry Pi + Arduino UNO and OpenPLC Full Download